Is not parallel! Look at how the switch is wired! No melted wire insultion, clean solder joints, no spatter.Īgain, that Seymour Duncan schematic is a parallel configuration. I checked the wiring myself as I was drawing it. If it is not, I want to meet the guy who did it, cause it sounds awesome! So I am drawing up a new schematic and looking for diagrams of the U3 and any Danelectro using the Select-O-Matic for a bit of direction.Ĭustomer swears that this how the wiring is from the factory. I have a rotary to allow for configuring the pickups such as with the Select-O-Matic, but I can not find a neck selector switch that is On-Off-On. What I am trying to do is replace a shorted 4PDT On-Off-On neck selector switch. Duck strings before hitting the US market. The word there is that the instruments came from Korea bone dry with crap strings. In my double-neck, the pickup selector is wired as in the diagram and gives me bridge/both/neck.Īs I understand it, all Danelectro's were made in Korea. Something that wouldn't be to easy in series. The Danelectro uses two stacked pot sets giving individual volume and tone control for each pickup. Also, the Seymour-Duncan diagram uses a master volume and tone setup. At least from the point after the neck selector switch. All I can do is verify that the diagram does match what I have in my re-issue double neck. I can not tell you if the diagram on the link is true to the original U2.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |